17/03/2026
Difference between EHF and BRR mode
Our users often struggle to grasp the difference between the device’s operating modes initially. Let’s clarify this!
1) All modes in the Spinor device are EHF modes because it is an EHF therapy device.
2) During an EHF session, we select an emitter and work with the frequencies of the emitters, as well as the frequencies of the device itself, if we use Spinor with 11 modes.
3) Inside the emitters, there is a crystal that can record the body's frequencies and re-emit them (BRR mode)
4) When we perform EHF therapy (the device is turned on, for example mode 7), the crystal reads its own oscillations at the same moment. If after EHF therapy we want to influence with the recorded frequencies, it is enough to leave the emitter ( turned off) in the same place for the BRR mode for 8-12 hours.
5) If we don’t need an EHF session but want to record information from an organ, we use Mode 2. This mode was separated for convenience, as recording information takes only 1 minute.
6) The most difficult point to understand is that mode 2 is also EHF, for example, it does not differ functionally from mode 1, only in duration👀
7) Ideally, combine EHF mode and BRR mode to increase the effectiveness of treatment.
Please ask in the comments if you still don't have a complete understanding of this issue 👇
