Jinqu wind instrument

Jinqu wind instrument Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Jinqu wind instrument, Musical Instrument Store, Luoyang.

Yanason Natural 5 key Horn
08/08/2022

Yanason Natural 5 key Horn

Yanason Saxphone
28/07/2022

Yanason Saxphone

customer make a video of palying our flute. please check the link:
12/03/2020

customer make a video of palying our flute. please check the link:

Basic maintenance of the clarinet1. The body of the clarinet is made of natural wood (GRENADILLA), so it is very sensiti...
14/01/2020

Basic maintenance of the clarinet
1. The body of the clarinet is made of natural wood (GRENADILLA), so it is very sensitive to rapid temperature and humidity changes, which is also the reason for the damage and rupture of the body. Therefore, for the use of newly purchased instruments, the first playing time should be short (about five minutes), the second ten minutes, the third twenty minutes, and remember to coat the inner and outer tubes with BORE OIL to Prevent wooden tube from cracking.

2. Lubricate the joints with CORK GREASE before installation. Please be careful not to apply force on the keys.

3. When removing the water in the tube, use the wiper (M) to pass through the tube to completely remove the water inside. The joint is susceptible to moisture. Please use a cleaning gauze to carefully remove the moisture to avoid cracks. (M) refers to medium-sized rod cloth.

4. After playing, be sure to remove the reed and wipe off the water for safekeeping. After the mouthpiece is used up, it should be cleaned, and then use a rod to insert water from the joint to remove water.

5. Clamp the absorbent paper between the pad and the sound hole to absorb the moisture, taking care not to damage the pad.

6. When removing surface dirt, wipe gently with a cleaning cloth (POLISHING CLOTH) along the body of the tube. Do not apply force on the keys to avoid injury to the leather pad. In accordance with the cleaning of the pipe body, use the sound hole cleaning stick to perform detailed cleaning on the lower side of the keys and the gap.

7. Frequently check if the keys are flexible and the screws are loose. Use of Key Lubricant: Apply a small amount of Key Lubricant (KEY OIL) to the part of the key screw. You do not need to loosen the screw. Don't drip too much. If it gets on the tube, wipe it off. Sound hole cleaning: Please use the sound hole cleaning stick to remove the dirt on the key sound hole.

8. Note: After a period of time, electroplated wind instruments will have a discoloration on the surface. This has no effect on the performance of the wind instrument. As long as it is wiped, the original gloss will be restored.

Basic maintenance of flute or piccolo1. When the piccolo or flute is shipped, in order to keep the cork at the joint cle...
06/01/2020

Basic maintenance of flute or piccolo
1. When the piccolo or flute is shipped, in order to keep the cork at the joint clean, no cork grease is applied, so a small amount of cork grease should be applied during installation to facilitate disassembly.

2. After playing, the water in the tube should be removed: Pass one end of the cleaning gauze through the hole in the front of the cleaning rod, wrap the cleaning rod with gauze, and insert it into the tube to slowly rotate to remove water.

3. If the pad is wet after playing, please clamp the absorbent paper between the pad and the sound hole to completely absorb the moisture. It is best to use power paper to keep the pad dry after the water is removed.

4. Do not apply excessive force when wiping the keys to avoid affecting the tightness of the keys.

5. Perform routine maintenance once a month: check the condition and tighten the screws to prevent the screws from loosening naturally. Put a small amount of key oil on the active part of the key. Be careful not to drip too much. After dripping, press it up and down a few times to completely pe*****te the oil. If the surface of the key gets oily, wipe it clean.

6. If the position of the reflector of the mouthpiece is deviated, the pitch will be affected. Please use a cleaning rod to determine the position. The method is to insert the cleaning rod into the head tube and check whether the scale above the cleaning rod is aligned with the center of the mouthpiece.

7. If the reflection plate is deviated: When it leans to the right, loosen the top cap, press the reflection plate to the left, and then lock the top cap (note that the front of the cleaning rod should be wrapped with gauze to avoid hurting the reflection plate.) , Loosen the top cap, press the reflector to the right, and then lock the top cap.

31/12/2019

Saxophone basic maintenance

1. If the leather pad is wet after playing, please use absorbent paper between the leather pad and the sound hole to absorb the moisture. Be careful not to leave any water on the leather pad to avoid shortening the life due to hardening.

2. When removing the water in the tube, pass the CLEANING SWAB of the sax rod group through the bell mouth and then pull it out of the neck tube joint several times.

3. Remove the reed after playing, and use CLEANING SWAB (s) to remove water from the mouthpiece and neck tube. (s) refers to a small strip of cloth.

4. To remove surface dirt, use a cleaning cloth (POLISHIN GCLOTH) to remove fingerprints and dust on the surface of the tube.

5. The sound hole of the overtone key is small and easy to be blocked, so you should always use a sound hole cleaning stick to clean it.

6. Clean the fine parts once a week: remove the fine dirt around the key link; make gauze into a strip and gently clean between the links; use the sound hole cleaning stick to clean back and forth between the keys gently, pay attention Don't hurt the pads.

7. When using key oil, apply a small amount of key oil to the chain screw (do not loosen the screw). Be careful not to drip too much and wipe it off if it gets on the tube.

8. The neck tube is cleaned about once a month: Pour the detergent solution (BRASSSOAP) into warm water at about 30 ° C to 40 ° C (appropriate ratio of detergent: water = 1:15); The pad connecting rod is removed, and the cork is wrapped with tape to prevent it from being stained with the solution. The brush in the SAx cleaning group is dipped in the cleaning agent to clean the tube. After the dirt is removed, it is rinsed with water. Use a cleaning cloth (CLEANING SWAB) Moisture absorption; install the pad pad connecting rod and finish.

30/12/2019

· Bronze brass instruments are composed of several keys (usually three or four, but there are also seven or more). The length of the pipe is adjusted by the player's fingers as needed for performance. This family includes all modern brass instruments except the trombone (Trombone):
High Musical Instruments: Trumpet, Cornet, Flugelhorn
Chinese Musical Instrument: French Horn, Marching Horn (Mellophone)
Tenor Musical Instruments: Euphonium, Baritone
Bass instruments: tuba, Sousaphone, Trombone
And the Saxhorn series used by outdoor bands.

27/12/2019

Thank every friends for following the store and liking it

Address

Luoyang
471000

Telephone

+8613838829612

Website

Alerts

Be the first to know and let us send you an email when Jinqu wind instrument posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category