Smith CNC Patterns

Smith CNC Patterns Patternmaker

Motorcycle wheel hub, Photo shows the rear hub that was measured and patterns made to reproduce the part. Patterns and c...
28/04/2023

Motorcycle wheel hub, Photo shows the rear hub that was measured and patterns made to reproduce the part. Patterns and coreboxes shown are for the front hub , cast in magnesium in Australia

A personal project cast by Giltech castings for a water feature
28/04/2023

A personal project cast by Giltech castings for a water feature

On screen design in Solidworks, machined pattern in signex board, and the finished cast plaque displayed at Steam Scene ...
28/04/2023

On screen design in Solidworks, machined pattern in signex board, and the finished cast plaque displayed at Steam Scene in Mcleans Island

Im not clever enough to have carved these belt buckles, but I set them up for the foundry to cast them
28/04/2023

Im not clever enough to have carved these belt buckles, but I set them up for the foundry to cast them

This was to cast Ali yokes for 737 flight Simulators, needed to be hollow for the wiring to run inside
28/04/2023

This was to cast Ali yokes for 737 flight Simulators, needed to be hollow for the wiring to run inside

Pattern tooling for a cast Aluminium water tank, with thermostat housing
28/04/2023

Pattern tooling for a cast Aluminium water tank, with thermostat housing

An mdf torso, first photo showing rough machining, second one showing finishing, used for testing harnesses I think
28/04/2023

An mdf torso, first photo showing rough machining, second one showing finishing, used for testing harnesses I think

Here is another impellor pattern, This one was cast in bronze.
28/04/2023

Here is another impellor pattern, This one was cast in bronze.

A one bladed impeller casting, probably for pumping poo. Pattern and coreboxes for the foundry
28/04/2023

A one bladed impeller casting, probably for pumping poo. Pattern and coreboxes for the foundry

Pattern and corebox for this worn out Iron feed hopper.
20/01/2018

Pattern and corebox for this worn out Iron feed hopper.

Address

Christchurch
8083

Telephone

0211171729

Website

Alerts

Be the first to know and let us send you an email when Smith CNC Patterns posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Smith CNC Patterns:

Shortcuts

Share

Category